When i select the printer it starts to install a driver for it but a message comes up that says "No driver found" it asks me if i want to search for a driver on my comp but i don't have one to begin with. i have been to HPs website about there drivers and such and they don't have any drivers for Vista, they say the comp will look and find one for you while it did properly.

updating network printer driver-8

My printer is a HP Deskjest 340 and it is connected to an i Mac.

I have all comps networked together so when i click add a printer my HP shows up as connected to my mac, no problem there.

When i select the printer it starts to install a driver for it but a message comes up that says "No driver found" it asks me if i want to search for a driver on my comp but i don't have one to begin with. i have been to HPs website about there drivers and such and they don't have any drivers for Vista, they say the comp will look and find one for you while it did properly. Unplug your printer from your i Mac upstairs and connect it on W7.

It should be detected as a local printer and the necessary drivers will be installed.

Then , disconnect it and put it back to you i Mac upstairs.

Now try connecting to it again as a network printer. System Manufacturer/Model Number ENIAC OS Windows 7 RC 7100 32bit/64bit CPU Intel Core2Duo E4500 2.20 GHz Motherboard ASUS P5LD2-X/1333 Memory 2x1GB Kinsgston DDR2 800MHz Graphics Card Nvidia 8500GT Sound Card Onboard High Definition Audio Device Monitor(s) Displays Sony Bravia 42" Hi Guys Does anyone know how I can get this printer to work in Windows 7? One of the towers "could not find drivers" either as in your example.

Vista has the drivers already, and the Lexmark site does not list drivers for vista. My main is hard wired to the Fios router and has the Epson R1400 attached to it via USB. I finally had to use my installation disk for the Epson on the computer that could not "find" drivers and re did the "connect to my Epson" operation, it pulled and installed the driver from the disk and all was fine afterwards.

I have this printer connected to my network through a HP printer server, so basically the way I set it up on a system is by creating a standard tcp/ip port to the server. Does anyone know of a driver in Windows 7 that will work? Very odd that the others were able to pull the driver from the main machine where the priter resides.

At this point I just happy that all four machines are seeing and using the same printer though I can't figure out why it could not grab the drivers from the 1st like the others.